Triple-barrel Flame Thrower

Triple-barrel Flame Thrower Product Description

Introduction:

• The small switch at the rear is the main power switch. OFF = Power Off, ON = Power On.
• The large switch at the rear: Position 1 = Each button controls its corresponding flame tube individually. Position 3 = Any button simultaneously controls all three flame tubes.
• The three square buttons on top are the firing buttons.
• The round hole at the rear is the charging port.

Operation:

1. Prepare the provided special consumable paper. Ensure it is completely dry before use. Insufficient drying will prevent flame projection or cause only smoke.
2. Set the main power switch to OFF.
3. Prepare a piece of consumable paper approximately 7x10 cm for each tube.
4. Crumple and twist the paper into a cylinder roughly matching the internal diameter and depth of the flame tube (approx. 8.4mm diameter x 16mm long). Rotate the paper roll while inserting it into the tube. The inserted roll must fit snugly against the tube walls with no air gaps.
5. Gently press the paper down using the wooden stick until it touches the bottom and makes contact with the filament. Failure to reach the bottom and contact the filament will prevent ignition and flame projection. Ensure no gaps exist between the paper roll and the tube wall, as gaps cause air leaks, resulting in short flame projection or combustion only at the tube opening.
6. Turn the main power switch ON. Press a firing button to project flame.

• • (Note: Inserting the paper roll requires skill and practice. Success may not come on the first few tries for beginners. Carefully study instructional materials while practicing to master the technique. The ability to project a fireball and its distance depend entirely on the quality of the paper insertion.)

Tips:

1. Never touch the firing buttons while inserting paper. This prevents accidental ignition in case the main power switch was accidentally left ON.
2. Until you are fully proficient in paper insertion, hold the prop by pinching its rear section between your thumb and forefinger when firing. Do not cup it in your palm. Inexperienced insertion may cause the fireball to fail to project, instead emitting flame directly from the opening, which can burn your palm. Only after successfully projecting fireballs several times in a row, attach the transparent protective shield to the prop. Only then may you fire it while holding it in your palm.

Warnings:

• ALWAYS turn the main power switch OFF before inserting paper.
• Professional magic prop, not a toy. Prohibited for minors.
• Never look directly into the tube openings. Use a mirror or phone camera to view inside if necessary.
• Never aim or fire at people, animals, or flammable materials.

Product Video: